1/2" Motorized Electric Ball Valve 9 12 to 24 Volt Slow Close, 3 Wire Control

Description

Untitled Document
HOLDS POSITION WITH POWER LOSS
9-24 Volt Ball Valve
Auto Detects Voltage
Function
Normally Closed
Connection
1/2” Inch FNPT
Temperature Range
15 – 250°F
Pressure Range
0 – 185 PSI
Power Requirements
500 mA While Actuated
XR33 Wiring Type
3 Wire Control
Operation Type
Bi-Directional
Closing Time
5 Seconds
*Suitable Media
Water – Air - Fuel -*Etc
Specifications
Body Material
Brass
Components
Stainless Steel
Seal Material
Viton® Diaphragm
Ball Seat
PTFE
Max Torque
2 Nm
Orifice Size
1/2"
Connection
Lead Wires
*Duty Cycle
100% but not indefinitely
Weight
12.6 oz
Height
3.92"
Length
2.24 port to port - 2.62" total
Width
2.56"
Ball valves are great alternatives to solenoid valves. While solenoid valves require large amounts of power to hold position, ball valves do not have this large power requirement. The Red wire hooks up to positive (hot) while the Black wire connects to negative (ground). The Green wire is connected to the positive through an inline switch, relay or controller. When both the Green and Red wires are energized, the valve opens. When the Red wire is energized and the Green wire is not energized, the valve closes. These are full port valves where flow is not restricted.
This ball valve is bidirectional, allowing for flow in both directions without issue. It is also slow closing, taking 4-5 seconds to completely open/close, eliminating any potential water hammer effect. The actuator is IP67 rated, the NEMA 4 equivalent, making this valve acceptable for outdoor use. While splash resistant, the valve should not be submerged in water. For convenience, there is a position indicator on the top of the valve.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
Listing and template services provided by inkFrog